Aqua-Pure AP717 Inline Water Filter for Refrigerator, Ice Maker and Drinking Fountains, Inhibits Scale Build-Up, Removes Sediment, Chlorine Taste and Odor

I installed this under my sink to help remove white specs from my ice. The install was pretty simple. I just cut the plastic water line with my kitchen scissors; just make sure you don’t cut at an angle. Snaps right into the filter and boom, done. The result was great, about 95% of the specs were gone. I’ve already re-ordered another filter so I can replace in six months. Per the attached image, I also use a 3M Complete C filter to remove chemicals. Great compliment to the AP717 for particulates.

I replaced a previous installed AP717 filter that was installed by my plumber a few years back. These new filters are much easier to install. You "push in" the plastic water lines on each side and they lock themselves into place with no water leaks. The plastic threaded fittings also came with with tape already placed on the threaded ends so I did not have to buy seperate teflon tape. A very nice product but please follow instruction and flush out the filter with water before final hookup and use. Ice cubes and drinks now taste much better.

I use this product for refrigerator ice machine and drinking water, just have to add pre sediment filter before connecting to this 3m ap717 filter, it removes the chlorine and whatever chemical they've added to the water system during process well maybe not a 100% but I sure the water don't smell and taste like chlorine and other chemicals also I can drink the water right out of the faucet.

This is simply the best in line water filter I have ever found. Costs more than the others but with the triple action is worth the price. Hooked up a side faucet to the kitchen sink to have purified water for cooking, coffee, tea. If you do anything like that or a water line for a refrigerator icemaker - this is the one to use. Even tastes better!

This is a good filter. Summary: Need to go a little past hand-tightening the fittings, and the zip-tie isn't long enough. Details: I use this 3M AquaPure for coffee maker, and another double-filter system for drinking water. As with that other system, this filter is good, but installation details need a little attention. The fittings are "pre-wound" with barely any plumber's tape. It should be enough, but hand-tightening as in the instructions isn't enough to prevent a leak. I tightened it about a 1/2 turn more with a wrench to get the leaks to stop. NOTE: Be careful doing this, they mean it about only hand-tightening, to avoid cracking the fitting. The other detail is the 7.5" zip-tie is barely long enough, where you can't really get it to do even one click. So I got a couple 10" ones, and tied them on easily, and cut them. These aren't the end of the world, but a little more tape (or just provide none) and an 8" zip-tie, and they'd have a nice system where you appreciate the attention to detail.

Always turn off the water to the supply line before replacing the refrigerator ice cube maker filter. Could have quite the mess if neglected. Otherwise, this is the same filter I replace every 12-18 months or so. Very easy to install after the plumber set up the supply line under the kitchen sink and we ran the line to the refrigerator. Unscrew the two ends, wrap the male ends of the connectors with couple rounds of plumbers tape and install. Tighten just to the point that no drips are observed and you're good for another 12-18 mths, depending on how much ice you make. Takes 90% of the unwanted taste out of the tap water. Iced drinks taste like it's intended without chlorine or other tastes and/or smells that can occur with municipal tap water.

I recently placed my second order for this product. The filter is easy to install and best of it works immediately. Just draw about two quarts of water out of it before using it for the first time. The last time I went a little too long before replacing it and I could tell the difference in the taste of the water. I change it about every four to five months. Found that is what works best for me.

Always have pre filter before ice-Maker

Fridge water and ice. Better to flush out carbon fines before installing outlet line, if possible.

all good so far good delivery time tks