Mini Tower Kit for Raspberry Pi 5, Case with ICE Tower Cooler, 0.96'' OLED Module, GPIO 1 to 2 Expansion Board for Raspberry Pi 5 8GB 4GB

I cut the plastic pieces off and staggered it just a bit so it would fit in the port cutouts. If you cut the same pieces off. And sand it down a bit it would fit perfect. As for the quality of the case itself of you consider the price it's quite the piece of equipment. After reading all of the reviews about the directions having spelling issues and all of the driver issues. I can say I ran into zero of those problems. And everything was very straight forward and well written in my opinion. I have mine overclocked and I have had no issues The screen is easy to change as well. The lights also look great! I have not had a chance to play with the configuration on them yet tho. But from what I read it doesn't seem like it's going to be hard either. 7

As of 2025 has a well written manual and if you follow the instructions you will not have any issues. If you want to run with NVME spend the few extra bucks on the version that has the underside hat for it. This kit is well thought out and is better than I had hoped. Burn in testing with this case was MILES better than the stock raspberry pi5 heatsink, my cpu never got over 59c at full utilization. Also, it looks awesome when assembled! The pictured on amazon don't do it justice.

Overall I like this better than my Argon Pi5 case, BUT they have completely neglected to heat sink the power management chip and memory. Even the minimal stock heat sink has cooling for those. I would like an option to stack my NvME (Pimeroni) under the Pi5. The case has room, but there is no provision made in the sled. If I had an STL I would 3D print my own sled with shorter mounting. As it is I stuck the SSD onto the back, since the cable only just reaches. This does allow better SSD cooling and access to swap it. But it looks like a kludge. The ethernet/USB should be on the back, with the OLED screen on the front. Of course that is personal taste what works better for your situation. Decent quality, and almost a home run. Easily worth the cost. Fits together well.

You must remove the bottom tray in order to attach the pi to it. You'll probably never see the fan spin. Be careful with its connector. Once inserted (with yellow wire at board's edge) do not remove it. Fan should show colors when pi is on. Somewhat difficult to get OLED working.

it's a really cool little case, had my 4b in it for a bit because my 5 was stacked too high with hats. super easy install and very classy way to protect your Pi. Great product! Thank you for bringing it to us!

It's a cool case but the nvme (or any other hat for that matter) is not compatible without damaging the case. Internal legs need to be shorter and have standoffs to accommodate possible hats

This is a grwat case for the Pi. Excellent cooling. Easy assembly.

Aside from the cool lights, there's nothing to like about this builky housing. You can't get to the SD card slot without some long nose pliers. The manual is riddled with typos which makes it impossible to install the drivers. The heavy duty fan is amazing but it only seems to work if you have the drivers installed. I have a note in to tech support to see if I can ditch the mini display and just plug the fan in to the GPIO header to run all the time. Rather than print a manual with typos they should just provide a link so errors can be corrected and updated on the fly. They also should have had a few people build this kit from their instructions to detect errors. I'll probably end up buying the regular Pi 5 cooling assembly and official Pi 5 case if I can't get the fan to work.