Case for Raspberry Pi 4, Universal HAT Size Pi Case DIY Kit, Protective Acrylic Case for Pi 5/4B/3B+/3B/2B/B+ and Pi Hat Expansion Board

This is just the protection I needed for a Pi3B+ running a squeezelite player on Raspbian. I tried the bare squeezelite player first, but had problems getting it started. Tried again with synaptic and it worked perfectly. The cutout for the next layer of GPIO pins is place correctly for the pins that can be added to a HiFiBerry DAC+ which as I type is playing beautiful music wirelessly. It replaces an OLD wired squeezebox. The best instruction for putting the pieces together is the picture on the Amazon page.

This was a great solution for my PI and a RF base station hat that has a wire antenna. The metal spacers are far sturdier than the usual plastic ones I have seen. When you don’t need walls, this is a great enclosure. I added my own feet to the bottom. My only nit was that it should have come with feet.

Fits my Pi 3 B+ with hat, however access to the 40pin header is limited. Might try with spacers when the need arrises. May buy another for a pi5

Simple, basic, and cheap. Open air design is great for a set up with no fan.

Ships with the surface protected by brown paper. Remove the paper and the shiny black surface is gorgeous. The gold-colored stand offs round out the ensemble. Really worth the money.

I bought this for the OrangePi 3B v2.1, the only items I was able to use from the kit were the screws and standoffs. I needed this for the usb expansion hat I added to my pi.

This is a good quality, easy to use case. It works fine for my Raspberry Pi 5. I like the flexibility these simple acrylic cases provide. I would have given it 5 stars but my kit contained only three medium sized stand-off (and an extra small one). I contacted the maker this about 4 days ago regarding this issue and have not heard back from them.

If you have another to board with the exact same mounting holes, this also works perfectly. I bought this for use with a Libre Computing AMLogic Le Potato board. Works very well and snug throughout. The group hole is slightly off, but it doesn't really matter for my builds.

Pour remplacer un boitier qui fait court circuit. Dommage qu'il n'y ait pas de pied caoutchouc, et pas assez de vis pour le dessus, les deux récupérés de l'autre kit

Kit minimalista ma di buona fattura.

Utilização com DAC com Raspeberry Pi 4 só foi possível com troca de espaçadores e adição de anilhas (não incluídas) . Diferença, para menos (3 mm), na montagem tal como apresentada.

Nacht macht es soll.

I like these cases for experience.entation with RPI hats.