ID-COOLING IS-67-XT BLACK 67mm Height Low Profile CPU Cooler 6 Heatpipes CPU Air Cooler for HTPCs, ITX, and Small Form Factor Builds, 120x15mm Slim Fan, Support Intel LGA1700/1200/115X, AMD AM5/AM4

So, yes, it works and works well. Compared to the Noctua NH-L9x65, I am getting much better idle temps - due to, I assume, more mass and a larger fan.However, the mounting instructions are poor - the short bars and long bars for AM4/AM5 are to allow 90 degree rotations of the cooler to ensure motherboard compatibility, in terms of RAM and VRM heatsink clearances. I can confirm it fits well on the ASUS ROG Strix B650E-I Mini ITX Motherboard in a Fractal Ridge case, if that helps anybody.

I just assembled a gaming PC in an ITX case Fractal Design Ridge and the cooler fits perfectly and paired with R7 7800x3d runs flawlessly, no problems with the RAM modules either.100% recommended.

Haply with it

Excellent product and good priceNeeds motherboard out to fitBut quite easy and sturdyDoes the job

Great little cooler.

So far ID cooling has done nothing but impress again and again. Put this in a mini ITX build that I was looking to make as silent and light as possible. Did a fantastic job. I did swap out the fan for an ID cooling 120 mm as I had a ryzen 7 700x with a very 3060 12 GB that I repaired after a friend said it was toast. Just needed a mosfet replaced. Anyway, great fan!

Works a treat. Really easy to install

My first unit was defective - the threads for the fan to screw into were missing (they were just holes) so I couldn't attach it.The second unit was fine but had some rough manufacturing on the metal.Neither unit came with any instructions which was very disappointing.It's not rocket science to install but it certainly would have benefited with some clear instructions.It does perform well and cools my 5800x to around 65 degrees under load while maintaining a good noise level, but I'd definitely opt to avoid ID-Cooling in the future when selecting my next cooler.