Legrand - Pass & Seymour radiant RWP26DBCC6 1-Gang Screwless Plastic Wall Plate, Decorative Outlet Cover, Oil Rubbed Bronze Finish, Dark Bronze

fits great and looks fantastic

“These wall plates make everything look instantly modern — like a mini home upgrade for a few bucks. The screwless design gives a smooth, professional finish, and they snap on snug with zero gaps. Install took seconds, and they’ve stayed secure even after a few swaps. The white matches standard outlets perfectly. It’s the little detail that makes the room feel finished — a bright idea, literally.” — Praying to the car gods

Nice quality, actually better than Lutron version that I have used elsewhere. Study, clean look, easy installation. Cover removal is easy as well for cleaning or painting walls.

Recommenfed, but they ate pricey compared to the basic wall plates for devora light switches and electrical recepticals (outlets). But they do get rid of the screws showing and add a cleaner look. Electrician"s tip: Just know that the top and bottom corner metal tabs (the ones that look like mouse ears) on any switch or receptical, are there so you can bend the up to push the switch or receptical off the wall surface as needed to make it sit level and flush. Simply use a small screw driver and fold the tabs downward to lift the switch or receptical higher from the surface of the wall and/or the electrical box. This helps if the wall is uneven plaster, drywall, or textured or even stucco on exterior walls. Also helps for electrical boxes that are recessed too far into the wall. Never just tighten down a switch or receptical to the maximum and against the electrical box, unless that is even and flush with your surrounding wall surface. I like to use a small allen wrench to bend these tabs, as it as a short and long side to allow better leverage or in tight spaces. Once level and flush you can tighten the screws on the inner part section of the wall plates untill they sit flush too. Then just click on the top cover, with the two slots holes down. Then just use a small flathead screw driver in those holes to remove it when needed. I usually just gently lift it from the bottom and they pop right off. I also bought the 2 and 3 gang (2x 3x switches or recipticals) to use where I had multiple gangs in my kitchen and bathroom.

Worked well - standard dimensions

Can be a bit tricky to get flush to the wall, but these are the most flush plates I've seen.

Simple to attach holding piece and snap on wall plate. Clean appearance

This worked great for the installation of my skylight 27inch tablet. The quality of the wall plate was sturdy and thick