Silicone Protective Case Cover Compatible with Bose Soundwear Companion Wearable Speaker (Yellow)

Thing does NOT fit at all, completely ripped in half trying to slip it on the sound wear…..recommend DO NOT waste your money on this trash item

What you should know is this cover was extremely difficult to get on. It took 30 minutes and that was after I tried. I ended up asking my husband to put it on and it took him 30 minutes. I wouldn’t buy again. I bet when I change it will need to be cut off! Buy at your own risk.

I like this cover because it is open in the right places on the original cover the zipper was difficult to open after several sweaty runs. I’m not giving a 5 because in the back it sticks up a bit but it is not a deal breaker.

Hi I only speak up when I have something to say.......and I have something to say. This WILL fit you wearable speaker WITHOUT tearing itself apart. Needless to say, patience plays a large roll towards success but it is ok to stack the deck in your favor. Warming the cover will help make it more pliable; you can use a small hair dryer or tumble it in the dryer for 15 minutes at a medium cycle. Just bear in mind, while silicone is forgiving, an open flame can destroy it so I'd keep it away from the stove top; the same can be said of a microwave Stretching and smoothing a SMALL section at a time will deffinitly help; don't try fitting it all in one shot or it WILL tear. Additionally, the manual available through the Bose Connect app has a very useful ilustrated tutorial on how too remove and install a cover; yes, it refers to the cloth cover, but the same tips apply to this cover. You'd be surprised at how flexible this speaker is! As you can see in the pictures, the cover is form-fitting over portions of the speaker and whlie it is "droopy" over the openning, this will rest and hide against the back of you neck. So it does fit, it takes some patience, work a small section at a time and a bit of heat helps........my 98 year old Nana could do it. That being said, Peace out.

The big challenge that everyone describes is true. Getting it to go on and I could see how it would tear if you pulled too hard the wrong way. From Reading other post, I did like suggested and heated up with a blow dryer inside a little tiny plastic container as to drenched this cover with hot air. Then following the normal directions of how to put one on pull slowly almost like a very tight sock on the tips. What I did to keep from getting cold and and risk tearing it, I sat down I positioned the blow dryer handle between my legs and then with the gun of the hair dryer pointed out started slipping on the cover with the constant warm heat pulling it on slowly like I described. The end result that it is perfect fit and I'm so glad it was hard to get on because it wouldn't fit so great as it does now. Through this red one I can still see the power lights through the red silicone cover and I imagine it's probably the same with the yellow too. All the buttons fit perfect, it is a better fit than I imagined it. I would highly suggest getting this one but you must bring your patience for the perfect success.