Behringer Cx3400-V2

価格からは考えられない超高音質。 ただ、２台購入して減衰特性を左右の計４通りで ウーファー用、ミッドレンジ用、トゥイーター用として測定したが 写真のように、かなりバラツキがあった。 これだけの機能を盛り込んで低価格で仕上げているので仕方がないと思っている。 それよりも、低価格が音質に影響していないところがとても嬉しい。 ただ、電源の投入・切断 時（スイッチ、供給電源の何れでも）には、 ３ウェイの全ての帯域からポップノイズ（トゥイーターの帯域でも低域を含んでいる）が 出るので要注意！ 私は、パワーアンプ側の電源を切り忘れていたので左右のトゥイーターを壊してしまった。

Hey I got this to replace (other brand) Small Box / SX45 Two Way Crossover. It works well. I'm using it with my Old Yamaha receiver, with the jumpers taken out which makes it / switches it to a PREAMP. so Using for now as a 2.1 setup. Currently I only have 1 sub, I set the Behringer SUPER-X PRO CX2310 V2, crossovers according to how I want it, adjusted the levels etc.. I am using the subwoofer output for now, but Once I Get 2 subs, I will switch to the dual low outputs. Hopefully it works just as well. so it would then be switched to a true 2.2 Stereo setup (2 / Stereo subs) I'm not a pro audio guy, but I Can say this works better than my previous SX45 and I Like it a lot. It's very thin or little depth in dimensions, I just put a short padding(old mouse pad/mat cut) at the front of my Yamaha and put the Behringer right on top. Most of the Yamaha preamp heat comes out the open space / section about mid-way back on top so it's fine. This is a great product. Even though it's look, and design if more pushed / put out for PRO AUDIO, I Can say it works great as a Home Audio Crossover, at least in my style of setup. It adds a lot of control to your setup, try it out. it's pretty easy to understand how it works. When using the actual dedicated sub out, personally I set mine to about 50/55Hz, and my speakers crossover to about 60Hz~ around there. This is how online guides, and people say to do it because the missing Hz/ Section is in a way added together by the high and low roll offs. I Don't know how else to explain it in my knowledge/wording.. but it works. Also go by your ears and understanding. Side note: My Speakers are low sensitivity 84dB, There is a tiny amount of hiss from the tweeters with the input and high output levels set to 0. I Don't mind seeing it's such a small amount of hiss and is normal in most cases(And is only noticeable putting your head / ear close to the speaker/tweeter), but I don't know how this would fair in HIGH SENSITIVITY SPEAKERS, Would there be a lot more HISS, I'm not sure. In the end you can also turn the levels down on the Behringer. Also the hiss could be dependent on the gear used beyond/before the Behringer Crossover. Take care and good luck trying out yours.

Rapporto qualità prezzo top. Per piccoli impianti è perfetto. Regolazioni efficaci e buon audio

Super article je recommande sans limite. Bravo Behringer toujours parfait

Excellent product certainly worth the money delivered in super quick time