Woodstock W1210A Polycarbonate Jointer Pal , Black , 1.4 ounces

This made setting my jointer blades a breeze. The finish I am getting now is amazing.

It works, not much more needs to be said. Made my life a bit easier. Now I just need to work on my woodworking skills... it doesn't help with that unfortunately 😕

I found this tool very helpful in setting my jointer knives however. It was not a once a done solution. I had to go back and use a straight edge to fine tune each knife. I found that this tool set the knives too high in relation to the outfeed table. My machine has jack screws so it was pretty easy to just give each end of the knife a small adjustment to get them perfect once I had them close with the tool. Still a huge time saver over having to go back and forth on each knife with the straight edge.

I read about this tool while researching new knives for my joiner. This tool allowed me to remain sane after replacing the knives!! It cut down on the time it takes to do the job, too. I recommend!!

This thing makes changing joiner blades a breeze. I have an old Craftsman joiner and the instructions say to set the blades .003" higher than the outfeed table. This is not designed to do that, but it does set them at TDC - provided you follow the instruction that came with the Joiner Pal. And it is easy!

I waited way too long to buy this knife setting jig. I have a couple of vintage jointers and I always set the knife's myself because I am just that good...lmbo. They ain't never right. After building a very nice piece of furniture ( Twice ) I broke down and convinced myself that I should buy this jig, maybe it might help, Maybe. OH GO TELL IT ON THE MOUNTAIN, This jig worked so fast and WELL, I was mad at myself thinking you dummy you spent hours trying to set knife's and this jig did it in just a few minutes. If you don't have a machine that auto sets knife's get yourself one or even two just in case.

Easy to use and it gets the blades pretty close, but there is still a little adjustment with my set screws to slightly raise or lower the blade. For the price, its worth it but its still not "set it and forget it"

Knife changes on my fussy old Craftsman jointer used to take three hours minimum. With the Jointer Pal I was able to swap out knives in 30 minutes, most of which was spent knocking out the old ones. Alignment was pretty good -- nearly as good as doing it the old-fashioned way. This inexpensive jig has turned a dreaded ordeal into a routine task.

Turned my old Rockwell/Beaver jointer brand new. Works very well

These worked Perfectly. I recommend them. I have had nothing but trouble trying to get a perfect set up for my blades and this did it.

Worked great when I followed the directions.

This Jointer Pal worked perfect, it has strong magnets to hold it and and blades in place. Well made and a great price.

Works as advertised. Made hours of tedious measuring by offering a repeatable process that enabled accurate set up of the jointer knives