WT Weld Cross Tube Hydraulic Cylinder 2 1/2" Bore x 16" Stroke x 1 1/2" Rod x SAE 8 Port x 3000 PSI

I have a 1955 ford 600 tractor with an old Wagner front end loader attachment. Problem i was having was that the loader arm cylynders were leaking and i was tired of having to clean up the leaking oil from them. I took the cylynders to a local hydraulic repair company to have them re sealed, and they told me it would be at least $300 per cylynder to have them re sealed, but that is only for new seals and if any thing else is needed, the cost would go up from there. Well, i decided to search around and try to find replacement cylinders. I found these on amazon and they are a perfect fit!! No modifications were needed, and the cross tubes fit directly into the original wagner loader pockets. Absolutly perfect fit and about $180 per, well it was a no brainer!.Keep in mind that the fittings on thes new cylynders are SAE o-ring boss (ORB), and my old hoses were NPT (pipe threads) so when i went to my local Orielly auto part store to have new hoses made, i just told them i need an ORB #8 male fitting on one end and they made the hose that way. Easy peasy. Fast shipping too!!

I received the hydraulic cylinder today and tried to install it. But the shipping plugs were screwed in so tight I couldn't get them out. I finally added a cheater pipe to the hex wrench and got the first one loose. But when I tried this on the second, I felt the inside of the plug start to strip out. I ended up having to take the cylinder to a auto repair shop just to get the shipping plug out! The mechanic had to drive the next size up hex driver in and use an impact wrench to finally break in loose! There is no reason that a shipping plug needs to be installed that tight and then painted over. Picture is of shipping plug after it was removed.

I installed this on my Kubota back hoe and found the base 1" tube was not welded symmetrically on the base. This made it impossible for the cylinder to swing within the rails. I used a grinder and cutting wheel to trim the outside off which made it work but thinned the outer edge of the base. I don't expect a leak at any time but wasn't real happy with the modification. It does work fine now and was the best priced option I found.

I replaced all the hydraulics on my tractor. I have not been nice to these to say the least. Ground the ends to fit the space I needed and have beat the tar out of these digging and blading. They have held up extremely well under the conditions. I hope to not need to replace them but if/when I do, I will be getting these again.

I used these to replace cylinders on a John Deere tractor. I had to modify the ends to make them fit. I also had to add about $20 in adaptor fittings. I have been running them with no issue. John Deere wanted $700 each. I did this route for under $300 for everything.

The product looks fine. Everything matched up and these (I ordered two) are going to work fine. However, if you have the option, DO NOT allow USPS to handle these. They stored them in a warehouse because my post man couldn't lift them into his truck. They weigh around 30 pounds.

Great product for the money .. I bought two to replace the cylinders on my John Deere tractor front push blade .. JD wanted $269 each , I received 2 cylinders in 3 days for $175 ..work like a champ

Great for a replacement for our Kyoti! So glad we found this item on Amazon.