7" Chrome Visor Style Trim Ring, 4.5" Passing Light Visor Bezel | Compatible for Harley Davidson Touring Road King Street Glide Electra Glide Ultra Limited 1962-Up

fit great and look great was shocked when they where actually where metal

The headlight clamps down okay if you use the stock rubber seal. However, the two passing lights, it will not clamp on properly and leaves them loose.

i eventually got them to be secure. they might not fit 99 roadking right out of the box. be prepared to get out your grinder. the tightening screw can bottom out before a secure fit is obtained. you may be grinding more and more material to get the relief needed to allow the rings to collapse far enough around the light to get tightened by the screw. the manufacturer perhaps worried too much about getting "no gap", but the gap is at the underside of the lights where it will never be seen. so.... stupid call there guys, stupid. we need enough relief to tighten these down!! the chrome looks of decent quality and the metal of the ring is also of decent quality. this brought it up from a one star rating. somehow one small one fit without grinding and the headlight one fit around the stock trim piece. both smaller light trims needed to be removed. they look pretty good when they are on. not sure why others didn't like the quality of the materials. materials are good, not cheap looking at all. the figment is mediocre to poor. worth buying at less money. oh well

These bezels are easy to install and look absolutely awesome on the bike.

Large trim ring went on the headlight no problem, looks good. Small trim rings do not fit the driving lights correctly. Tried two different sets in case I received a bad pair the first time, both were too large and wouldn't tighten on the lights. I had to cut a quarter inch off the end of the trim ring and squeeze it together to get it to mount properly. The large ring goes over the factory trim, but the smaller rings replace the factory trim rings and do not fit correctly. I suppose you could use tape or something to slightly enlarge the circumference of the light but why should you have to do anything at all?

One for headlight fits just fine the two for fog lights could nit get to tighten up

i bought these for my 2003 road king classic, and the middle big ring was too loose. It wasn't even close to fitting tight enough. I would pass if u have the same bike

Fits perfect