BASICFIL PLA 1.75mm, 1 kg, 3D printing filament , Grey

Basicfill is my go-to 3d filament. I always buy them as I noticed their 1kg spool is cheaper than everyone else and also in high quality. I have tried them on 3 different 3d printers, Flashforge Finder, Creality CR10S and the FLSUN QQS Delta. All printed it well with no issues whatsoever. It has never jammed on me and oritns very good every time. Just make sure to print on around 210 degrees and if you have a heated bed then it works really well on the Creality cr10s at 60 and FLSUN QQS at 70 degrees.

It is so easy to create clean models with a slightly mat finish which looks really great.

It created some great prints, i mainly used it for large terrain for wargaming but also used it for small miniatures and the results were not bad for a MFD filament printer though you can tell more on small minis, the extrusion was very good

Actually bought this to make visors for the NHS during lockdown. The Prusa RC3 visor was printed at 0.3 resolution so it wasn't asking a lot of the filament. That said, I printed a whole 1kg with no clogs , no jamming and no adhesion problems. I thought the shade of green was a nice shade and would have been good had I any left for St Patrick's day. All in all I would buy again.

*edit* I ordered two reels at the same time. Undone the second reel to see if it had any tangles in it. And lowe and behold it did! Absolutely useless.I design and sell items using my 3D printers. I go through filament. I used AMZ3D. I've tried the 500g reel of Red which was alright but these. Are. Shockingly bad. Will be returning to AMZ3D.Do not buy this filament. While the quality of the prints are good and the adhesion is as well. The reel is riddled with tangled filament.So it looks good and prints well but you have to either A untangle it all before printing or B, be there watching it for new tangles appearing.

This PLA is rather good. I had no issues with printing the joint for my mates photo prop. I was not expecting much but it really did the job rather well on my Wanhao Duplicator i3. The quality is really good. I tend to print with 216 nozzle and no bed heating. Hope it helps someone

BasicFil is actually a great filament for the price, comparable to Amazon Basics (more expensive and rising) filaments.It gives very strong prints and prints at the 'usual' temperatures, 200° nozzle 50° - 60° bed on a CR-10S type printer.

Have gone through around 15 reels of this filament.Can not fault it at all.It's my go to on a weekly basis.Have used black, blue, red, white..All have yielded great resultsUsually print at 200-220 depending on ambient temperature in room.Bed at 60-70.