Aluminum Tailgate Table for 2021-2026 Ford Bronco 2/4 Door, No-Drill Foldable Rear Door Molle Panel Table & Cargo Shelf, Rust-Proof Lightweight Storage Rack, Fits Base/Big Bend/Badlands

This is a very sturdy/strong table option for your Bronco. To me, it probably has the cleanest look and functionality. Install wasn't too bad but the instructions they give you are absolutely horrible. There are a few videos out there that give great instructions on how to install. Overall very happy with the product.

This fits beautifully! It did not come with any instructions however, I just YouTubed it and it was easy to follow. It came with three protection stickers. I used all three even though the video showed they used one I figured the more the merrier, especially on off roading adventures . It literally took me 30 minutes to install it, including watching the video. This is very sturdy and very beautiful. I can’t wait to use it on my fishing trips. It does not take up any space when you close the door so your trunk space is still a plenty. There is no noise when you drive around. It’s quiet like it’s not even there. I researched many other models and this one is by far the best spend your money and get it. I have a 2025 Badlands Sasquatch edition four-door

This replaced another product that a ton of screw and bolts to put together. This came ready to install from the box. It is very quiet going down the road, no rattle, like the previous unit. Only issues I have with it is, powder coat is horrible, comes off super easy. And the foam padding for insulation or scratch resistance is piss poor too. I bought RV dense foam strips and lock tight from auto zone. Snug and secure now! If it wasn’t for the powder coat I’d give 5 stars.

Love this drop down table, especially all the molle attachment points and side pockets. Purchased this with the intent of using it to cook our trail meals on come summer time. Install was super easy, took about 30 minutes doing it solo. The table extension is great and was a major deciding factor as to why I chose this one. When folded out it is stout and solid. I have used it a few times as a parts bench when doing other mods on the Bronco.

After receiving a package that was damaged on the outside, I expected the worst. But I was lucky to find the table on the inside unharmed. During assembly, I had to learn that one of the T-bolts was a smaller size and therefore could not be used. The local home improvement did not have anything similar, so I contacted the seller directly over their website. I provided them some photos and asked for a replacement. I received an immediate response and also was sent a replacement (Thank you Suki!) so I could finish my little project. As I am very picky when it comes to my vehicles (despite most of them being 4x4 and sometimes used off the beaten path), I did my best to avoid unnecessary scratches. So I measured everything and cut some automotive weather strips to ensure an exact fit. These are thick solid rubber and I prefer using this kind instead of the somehow flimsy open foam strips which came with the table. My add-on creates a tight seal with a smooth surface around the back opening of the table. During camping - yes, I go outdoors with my cars ;-) - it will give you a hard time when your tomato sauce gets too hot in the pot and leaves your whole tailgate splattered with red and greasy residue. Cleaning the crevices would be very difficult if not impossible without removing the whole table (by unscrewing 6 bolts), if not worse: Remember these lengthy openings where you are supposed to put the bolts? Tomato sauce, sand or just rain will make their way through them and accumulate inside the door and the foam that was placed there by the manufacturer. So sealing off this whole area seemed a good idea to me. While waiting for the missing T-bolt to arrive, I also decided to disassemble the BROADDDICT logo made of stainless steel (plasma cutting could be done more precisely, by the way) filed the rough edges and painted the lower plate. In my case, I went with a matte olive green - just to create a small color accent. I could have gone with a bright yellow matching some of the car's interior design but my youngest son preferred the olive: wish granted. Before inserting the T-bolts I had the locking ends covered in shrinking tube to enhance friction on the inside and reduce the stress on the paint (or should I say base coat because Ford uses not very much paint on the Bronco's inner panels?). Long story short: Some room for improvement (packaging, quality control regarding assembly hardware and sharp edges, cap nuts could be used instead of lock nuts) but the product itself is just awesome. Even without personal touches a really nice addition to every 2021+ Bronco for years to come. This thing is heavy duty and the fitment is PERFECT! ... as is the customer service.

This is a great tailgate table for my Bronco. It is very sturdy, quality gauge steel and took 30 minutes to install. My first use was at a tailgate at a Red Rocks Amphitheater concert and it handled well all the food and drinks we were serving up. A couple planned camping trips this summer will be a better test but it looks like it will be great. Best I get no rattling from the Broaddict table when driving around which others have complained about tables from other manufacturers having noise problems. The directions were somewhat lacking enough detail and could be improved with 1. a much larger blow pic of the assembly of the two types of bolts with washers, nuts and sleeve. 2. directions on where to apply the three foam cushion strips. I applied two on either side of the top mounting holes and 1 below the bottom mounting holes.

Well, designed, very functional and well built, fit was good, worth the higher price. Installation instructions are too brief, so watch the videos and when you remove the plastic cover for install, make sure you remove from the bottom and pivot the top off the plastic angle tabs.

Best thing I have put on my Bronco to this day! Its easy to install, sturdy, quite, and has a lot of surface area!

It's a good table, but it came without any instructions, and also when mounted it's level is -5 degree off. For this price I'd expect it to be absolutely flat leveled.