Hoypeyfiy 3500 Watt Generator AVR Automatic Voltage Regulator Rectifier 3.5KW Half Moon for 168FA 168FB 170F 5.5HP 6.5HP 7HP Gasoline Engine

Plugs in the same as the old one, fits, just have to adjust the screw up like 6 or so turns clockwise. I'll have to turn mine back slightly because its pushing 124volts under load but there is a 20% leeway on voltage for it to run safely.

Excelente producto recomendado 100%

Found a generator in a trash pile and brought it home to see if I could get it going. I got the engine going relatively easy, but it would not output full voltage. I did my diagnostics and determined the AVR was bad. I found this one and it was affordable, so I decided to give it a shot. The part was easy to swap out and fit perfectly in my application. The only problem I had was that the voltage was still not 100% so I had to adjust that on the AVR. Once I got the voltage adjusted, I put it all back together and it has been working fine since. I forgot to do this review, so it has been a little bit and has been used a little bit.

Perfect fit for Champion 3500 (Honda clone) You really need a multimeter though to complete install. First you need to set the meter to Hz and dial the governor screw on the motor to get to about 60-61.5Hz. Then switch to volts AC on the multimeter and dial the Blue potentiometer clockwise on the AVR (the piece being reviewed ) to move voltage up to 120v. You need a very small screwdriver for the potentiometer

I'm always hesitant to buy very low priced parts but this fixed my problem and seems to be working fine. I'll buy another Soo. Just to have as a back up. I live in Florida and it's a necessity to have a portable gen ready to go.

This AVR looked and fit like the original AVR for my Champion 3500/4000 watt generator, model # C46540. Solved the problem of the generator putting out much less voltage than normal. Now, when set to 120 or 240 volts, I get the correct voltage. I had to fine tune the voltage adjusting screw on the back of the AVR to get correct voltage, but very easy to do.

Our champion 3500 generate wasn’t working, so we check out a few videos on YouTube and they all pointed to the avr part. It wasn’t producing any electricity. Found it on Amazon for a nice price and now the generator runs good again. Saved the generator and saved us $$…. Worth it !!!

When you first get the avr its simple plug and play red wire is always positive it did not say it was positive on wires,next when I tested it running its output was only 102 voltage thats not enough, avr was not adjusted to 120volts. When new you have to move screw clock wise while meter is on to get the right voltage... thats something the seller should tell the consumer had to figure it out on my own.

Pleasantly surprised, easy-ish install (7mm sockets required) Champion generator 3500w Good product so far.

Se quemó a las pocas semanas de haberlo comprado

So far so good. I installed it to replace the AVR in my Benchmark 4650E. Although this AVR is a 6 wire model and the original AVR has 8 it still works. I believe the 2 additional wires controlled the warm-up period. With this AVR installed it generates electricity immediately. You just have to make sure to not put a heavy load on the generator until it warms up.

Great controller for small gensets