Tuff Coat Medium Texture Rubberized Non-Skid Deck Coating – Textured Non-Slip Safety Surface for Pool Decks, Docks, Boat Ramps, Patios, Walkways & High-Traffic Areas (UT-203 Caribbean Blue 1-gallon)

I used this product to protect the boards on my trailer so they don't rot over time because it is left outside. Before applying it, I applied their adhesion primer after pressure washing. It looks great. I am not sure about its durability as it is only been on a few weeks, but it appears that it will stand the test of time. I used the beige color to reflect the sun. The sand like particles in the mix makes it completely non-slip. I would recommend this product, but use their primer and roller to apply properly.

Great stuff, cleans easily and stay on

Easy, at my door.

I followed the steps per the manufacturer. I had spent the money for the recommended primer from them as well. The primer was applied and adhered days before putting down the first coat. After applying two gallons to my dock, it looked great. About 9 hours later it rained. I woke up and found most of the coating gone. There was some where I read it can be dry to the touch after 30 minutes so I figured it should be fine hours later. Nothing was noted in any instructions about rain. After contacting the manufacturer about the issue, the only response I got was that it requires 5-7 days to cure. Not possible to predict weather that far out so probably not the best for docks. I would not recommend this for any surface that can’t be protected from rain for 5-7 days. Very disappointed in the manufacturer as this is an expensive product and did not work.

Hmm, first scare was a badly smashed can, from shipping. But it was the bottom so, no leaks. Used a stirrer from the hardware store and got it mixed really well. First go at it and it went on kinda clumpy, too thick and slid around on the slick primer surface. Couldn't get it even enough. Decided to thin it with a little water for the second coat and it went on much better. Dries to touch fairly quickly for second coat. Coverage was adequate and looks good. Hope it holds up over the years. This application was the deck/floor boards in my boat, one gallon for an 18' Aluminum boat with wood decks.

Material goes down really well, it’s thick and durable. I used it for the inside of my aluminum boat and it worked very well. Just need to make sure that you mix it really good with wood mixer or paddle on a drill.

It's been a year now so I figure I would review it, put this on my pontoon boat with brand new decking last year. Dogs, kids, beach trips etc, parked outside all year, I don't have a complete boat cover for the pontoon, only have furniture covers, and the floor still looks brand new after a little soap and water rinse. It was easy to install, mix well, and roll out. I've always done more layers and thinner coats when painting, that process did not disappoint with this product, it's strong and looks great. Cover everything you don't want this on permanently, it will stick to everything it touches! Spend the time to prep your painting area, the clean up is 5x longer then preparation.

I think it would work great on a small cement surface. I put it on a wood ramp with spaces between the wood. It’s OK. I just want to see how long it’s going to last. It does have good traction.

A+