ST Blade Fuse Block 6 Way Circuits with Negative Bus and Cover, 100 Amps, 5025

This works great I use it on my truck I run my radio and off-road lights through it it also makes it nice if you want to add other accessories and makes it extremely easy to wire them in to this fuse box and it's protected so you don't damage your vehicle's electrical system. It's good quality comes with fuses and pretty good directions if you're not good with wiring.

Best on the market.

I installed it on a boat. Seems to work well.

I really like this fuse block. It looks and feels nice and solid. I installed it on my motorcycle (under the seat) so I easily can add accessories to it. Once connected the fuse block via a relay to a switched 12V wire, I only have to connect the pos. and neg. wires of the accessories to the fuse block. Very easy, and no messing with inline fuses. I also like that it has a pos. and neg. side, so I don't have to connect all the negative wires to my battery or grounded bolts. It just makes it very clear, also with replacing fuses. Another thing I like is the cover. I can put lugage on the fuse block without having to worry about damaging it I strongly recommend this product to motorcyclists who like to install accessories. It's way better than the cheap Chinese fuse blocks. Also way cheaper than the very expensive ones like the FZ1, which in my opinion you don't need, unless you want specific accessories turned on by ignition and other ones turned on always.

Update 7/7/2020: Ordered a replacement via amazon that arrived the next day. I had originally contacted the distributer on the recommendation of amazon and have yet to get a reply. So I just returned the original unit and purchased a new unit. Same outcome, just faster. The new unit is working great so far with my 24 volt battery bank. Hopefully it was just an isolated quality control failure. I have connected the main #10 post terminals on this fuse block to busbars on my battery box using 4AWG wire with #10 ring terminals. The 4AWG wire fits well and the cover clears the wire without needing any modification. The posts for the individual circuits are #8 so I have connected each of them using 10AWG wire and #8 ring terminals. There is plenty of room allowing the cover to clear everything nicely. The additional wires on the posts that can be seen in the original photo I posted of the failed unit are leads from a 24Volt battery charger/power supply that is fused separately. The photos contain the information I found on the Blue Sea website that shows the dimensions of the 6 circuit and 12 circuit fuse blocks. Original Review; This seems well made for what it is and made for a clean install. I am concerned about the quality of the electrical components since one of the six circuits was dead on arrival. The same wire and same fuse work in all of the other 5 circuits but do not work in the number 2 spot. I will send this one back and order another hoping my experience is an exception and not the normal, either way it is not very confidence inspiring for an electrical safety device to come new with a failure. I will update the review after receiving the replacement and returning the faulty unit.

Great 12v fuse block

This was an awesome need in my car. I set it up to turn on with a sensor that has a delay to not interfere with the start up power of the car (so the car turns on and a few seconds later this fuse box is powered that then powers my other connections). I was able to hook up multiple connections to this. I use it with: a car charger port, a kill switch feature, my load connector to an amplifier I have connected to the stereo, the color lights I installed in the car, color lights under the car, lastly a power inverter I almost never use but it’s there. Awesome to use if you install it correctly.

Picked this up as I was rigging out my Matecumbe 169. I dont need a lot of capacity, as the only connections that will run thru this are nav/anchor lights, GPS/DepthFinder, and a manual switch for my bilge pump. Two screws mounted it, I ran to the main power cutoff switch, with a fused link in the power cable, and ran the negative lead to the battery. I like that the ground was a part of the unit, removing the need to run a separate block for the black wires. Comes with little stickers for noting what is wired to each connection, but if your handwriting is as bad as mine, you may want your wife to print the info on them. LOL Seems like a fairly well constructed piece of equipment, so i really expect no issues with it. Overall, no complaints, other than the fact that Im too old and stiff to work inside the confines of an enclosed skiff locker.

Excelente artículo. Rápida entrega 👏👍

I really rate Blue Sea products, and their fuse blocks are no exception. They’re solidly built, clearly labelled, and everything fits together exactly as it should — no fiddling or second-guessing. Compared to some of the unbranded or look-alike versions out there, these are in a different league. Yes, they’re a little pricier, but you’re paying for reliability and peace of mind — which is exactly what you want in an electrical setup. Definitely a worthwhile investment if you want something that just works and lasts.

1a Ware, würde ich sofort wieder kaufen

)

Good build quality. Using it in my car.