AC Infinity Quiet Cooling Fan System with Speed Control, for Home Theater AV Cabinets (6)

Great fan, very quiet and perfect retrofit for my cabinet.

Muy silencioso, excelente calidad, es posible conectar múltiples kits a un solo puerto USB, además de incluir eliminador en caso de requerirse. El tamaño con todo y placa es de 15 CM y cerca de 4 cm de profundidad

I bought this to replace another brand fan that exploded when I turned it on the first time. What a difference with this fan! Super quality, well-packaged, comes with a good manual and a helpful template for the cutout and screw holes. My only complaint is that it comes with a flat-pin plug, so you will need an adaptor to plug it into Indian sockets. I installed it in my home theater unit, which houses all my electronics, including a UPS, WiFi router, and a bunch of other things. The fan brings down the heat by almost 4 degrees in L mode and about 7 deg C in H mode. It runs quiet and cannot be heard when the TV is on. When the room is silent, the noise is audible but acceptable. It is not cheap, but from first impression, it is worth the added cost. Hope it lasts!

This fan works GREAT and QUIET. I have this fan installed in an enclosed TOP Back blowing air out of an enclosed cabinet. The BOTTOM back of the enclosed cabinet has about a 5 inch round hole. The fan can easily change the flow of air based on your situation. I also purchased the AIRCOM S9 and that is also PERFECT. This is a good set-up for my situation based on my opinion and probably will not fit your configuration. I have a ROTEL AMP and then the AIRCOM S9 sits on that blowing air up and a ROTEL PRE-AMP sits on the AIRCOMS9. So, the AIRCOM is in the middle of the AIRCOM. My previous fan was so loud, it seemed there was an airplane taking off in my family room. Oh, the AIRCOMS9 is set for 3/4 on as that seems to be a good setting for me based on moving air and noise. Other reviewer have also set it at this setting.... I used an accurate temperature gauge 6-inches from the open gaps of the Rotel and it was registering 150+ degrees plus WITHOUT the fans. The fans bought the cabinet temperature to 10-12 degrees plus the temperature in the house (ie house temp is 75 then the cabinet would be around 85 degrees 6 inches above the rotel opening). THIS IS FANTASTIC. The product looks GREAT and it is QUIET!!!! It looks PROFESSIONAL.... Oh, I have a power strip so there is no reason for me to buy the remote option. I don't want power constantly going to the Rotels as our electric flickers too much!!! But, I do like remotes. Oh, the fan comes with a cut out for easy installation!!! What a GREAT product.

I was frankly surprised by the quality. Nicely brushed anodized aluminum mounting plate so that one may have it on a visible side if one wished. Decent installation instructions were included along with a plastic template. I bought an additional fan with the temperature controller and plugged this into that and it all works together nicely. Someone else mentioned that there was some vibration -- but while that may be true, it's minimal and unnoticeable in my application since our console has a hardwood backing of some density and strength. I suspect the other reviewers backing (an Ikea product) may not have had the same ability to dampen vibration. Which points to something that should be taken into consideration -- if your application and contemplated placement is too thin then you could consider a visible side as the mounting plate is quite attractive and wouldn't be a eyesore by any stretch. So, on the low setting the fan runs very quietly and undoubtedly will last a good many years.