Waterproof K Type Grounded Thermocouple - Jaybva Temperature Sensor Probe for PID Temperature Controller Two Wire Stainless Steel NPT 1/4 inch Pipe Thread 0~500℃ with 2m Insulation Lead Shield Wire

Well made product did the job as expected for my outside fish pond.

Very good

Worked . But wasn’t sure if this is the one that burnt out quickly

This will monitor the heat in the powder coat oven.

This is a nice probe for the price. Couldn't find anything flaws on the case and was easy to add a male plug for ease of change out. Four stars until I see how long it holds up. I'll be using it in a lead melting pot. It was within tenths of a degree when tested against a known probe and worked well up to 600°f without being in liquid lead. Will do that later. I don't think there will be any problems there but it's ability to last when used in and hours long sessions sporadically will be the telling factor. The male/ female plug sets were purchased at the same time for this project.

Works as described.

I can't complain when a sensor just works and this it does. I have my K type probe connected to an InkBird PID controller, replacing the stock one it came with. This thermocouple screwed right inside the existing 1/4" screw terminal in my pot and sealed up nicely when tightened. The temps read pretty darn accurately and the stainless finish on the thermocouple appears to be up to par. The braided cord on this probe is quite long and prone to nasty kinks, so be careful with it. All things considered I will absolutely buy this again if needed!